HP C6Y70UT#ABA, D8C61UT#ABA, C6Z94UT, Pro 6300 B5N09UT#ABA manual Removing the Front Bezel

Removing the Front Bezel

1.Remove/disengage any security devices that prohibit opening the computer.

2.Remove all removable media, such as compact discs or USB flash drives, from the computer.

3.Turn off the computer properly through the operating system, then turn off any external devices.

4.Disconnect the power cord from the power outlet and disconnect any external devices.

CAUTION: Regardless of the power-on state, voltage is always present on the system board as long as the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to the internal components of the computer.

5.If the computer is on a stand, remove the computer from the stand and lay the computer down.

6.Remove the computer access panel.

7.Lift up the three tabs on the side of the bezel (1), then rotate the bezel off the chassis (2). Figure 3-3Removing the Front Bezel

Removing Bezel Blanks

On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch drive bays that need to be removed before installing a drive. To remove a bezel blank:

1.Remove the access panel and front bezel.

Removing the Front Bezel 47