HP D8C61UT#ABA, C6Y70UT#ABA, C6Z94UT, Pro 6300 B5N09UT#ABA manual 17Extra Guide Screw Locations

Installing and Removing Drives

When installing drives, follow these guidelines:

●The primary Serial ATA (SATA) hard drive must be connected to the dark blue primary SATA connector on the system board labeled SATA0. If you are adding a second hard drive, connect it to the white connector on the system board labeled SATA1.

●Connect a SATA optical drive to the white SATA connector on the system board labeled SATA2.

●Connect an optional eSATA adapter cable to the black SATA connector on the system board labeled ESATA.

●Connect a media card reader USB cable to the USB connector on the system board labeled

MEDIA.

●The power cable for the SATA drives is a three-headed cable that is plugged into the system board with the first connector routed to the rear of the hard drive, the second connector routed to the rear of the 3.5” drive, and the third connector routed to the rear of the 5.25” optical drive.

●The system does not support Parallel ATA (PATA) optical drives or PATA hard drives.

●You must install guide screws to ensure the drive will line up correctly in the drive cage and lock in place. HP has provided extra guide screws for the drive bays (five 6-32 standard screws and four M3 metric screws), installed in the front of the chassis, under the front bezel. The 6-32 standard screws are required for a secondary hard drive. All other drives (except the primary hard drive) use M3 metric screws. The HP-supplied metric screws are black and the HP- supplied standard screws are silver. If you are replacing the primary hard drive, you must remove the four silver and blue 6-32 isolation mounting guide screws from the old hard drive and install them in the new hard drive.

Figure 3-17Extra Guide Screw Locations

No.	Guide Screw	Device
1	Black M3 Metric Screws	All Drives (except primary and secondary hard drives)
2	Silver 6-32 Standard Screws	Secondary Hard Drive

There are at total of five extra silver 6-32 standard screws. Four are used as guide screws for a secondary hard drive. The fifth is used for bezel security (see Front Bezel Security on page 80 for more information).

60 Chapter 3 Small Form Factor (SFF) Hardware Upgrades