POST Error Messages

POST Error Messages (Continued)

Screen Message

Probable Cause

Recommended Action

1152-Serial Port B

Both external and internal

Address Conflict

serial ports are assigned

Detected

to COM2.

Remove any serial port expansion cards. Clear CMOS.

Reconfigure card resources and/or run Computer Setup or Windows utilities.

1155-Serial Port

Both external and internal

Address Conflict

serial ports are assigned

Detected

to same IRQ.

Remove any serial port expansion cards. Clear CMOS.

Reconfigure card resources and/or run Computer Setup or Windows utilities.

1201-System Audio

Device IRQ address

Enter Computer Setup and reset the IRQ

Address Conflict

conflicts with another

in Advanced > Onboard Devices.

Detected

device.

 

 

 

 

1202-MIDI Port Address

Device IRQ address

Enter Computer Setup and reset the IRQ

Conflict Detected

conflicts with another

in Advanced > Onboard Devices.

 

device.

 

 

 

 

1203-Game Port

Device IRQ address

Enter Computer Setup and reset the IRQ

Address Conflict

conflicts with another

in Advanced > Onboard Devices.

Detected

device.

 

 

 

 

1720-SMART Hard

Hard drive is about to

Determine if hard drive is giving correct

Drive Detect Imminent

fail. (Some hard drives

error message. Run the Drive Protection

Failure

have a firmware patch

System test if applicable.

 

that will fix an erroneous

Apply firmware patch if applicable. (visit

 

error message.)

www.hp.com/support)

 

 

Back up contents and replace hard drive.

 

 

 

1785-MultiBay

(for integrated MultiBay/

Ensure the MultiBay device is fully

incorrectly installed

USDT systems)

inserted.

 

MultiBay device not

Ensure the MultiBay riser is properly

 

properly seated.

seated.

 

or

 

 

MultiBay riser not

 

 

properly seated.

 

 

 

 

1794-Inaccessible

A device is attached to

If using Windows 2000 or Windows XP,

devices attached to

SATA 1 and/or SATA 3.

change “SATA Emulation” to “Separate

SATA 1 and/or SATA 3

Devices attached to these

IDE Controller” in Computer Setup.

 

connectors will be

If not using Windows 2000 or Windows

 

inaccessible while “SATA

XP, relocate the affected devices to SATA

 

Emulation” is set to

0 or SATA 2 (if available).

 

“Combined IDE

Remove the affected devices from SATA

 

Controller” in Computer

1 and SATA 3.

 

Setup.

 

 

 

 

C–6

390742-002

Service Reference Guide, dc7600