Removal and Replacement Procedures - Ultra-Slim Desktop (USDT) Chassis

8.6Front Panel Assembly

1.Prepare the computer for disassembly (Section 8.1).

2.Remove the computer access panel (Section 8.3).

3.Remove any MultiBay device from the drive cage (Section 8.4).

4.Remove the MultiBay riser card (Section 8.5).

5.Lift up on the two green locking levers on the left and right sides of the chassis 1. This will unlatch the front panel assembly and push it about 1.3 cm (1/2 inch) out of the chassis.

6.Disconnect the fan and speaker cables from the system board and remove the panel assembly 2 by pulling it straight out of the chassis.

To reinstall the front panel assembly, reverse the removal procedure.

Service Reference Guide, dc7600

390742-002

8–7