Table C-1Numeric Codes and Text Messages (continued)

Control panel message

Description

Recommended action

 

 

 

 

601-Diskette Controller Error

Diskette controller circuitry or floppy drive

1.

Run Computer Setup.

 

circuitry incorrect.

2.

Check and/or replace cables.

 

 

 

 

3.

Clear CMOS.

 

 

4.

Replace diskette drive.

 

 

5.

Replace the system board.

 

 

 

 

605-Diskette Drive Type Error

Mismatch in drive type.

1.

Run Computer Setup.

 

 

2.

Disconnect any other diskette controller

 

 

 

devices (tape drives).

 

 

3.

Clear CMOS.

 

 

 

610-External Storage Device Failure

External tape drive not connected.

Reinstall tape drive or press F1 and allow

 

 

system to reconfigure without the drive.

 

 

 

611-Primary Floppy Port Address

Configuration error.

Run Computer Setup and check the

Assignment Conflict

 

configuration in Advanced > Onboard

 

 

Devices.

 

 

 

660-Display cache is detected unreliable

Integrated graphics controller display cache

Replace system board if minimal graphics

 

is not working properly and will be disabled.

degrading is an issue.

 

 

 

912-Computer Cover Has Been Removed

Computer cover was removed since last

No action required.

Since Last System Startup

system startup.

 

 

 

 

 

917-Front Audio Not Connected

Front audio harness has been detached or

Reconnect or replace front audio harness.

 

unseated from motherboard.

 

 

 

 

 

918-Front USB Not Connected

Front USB harness has been detached or

Reconnect or replace front USB harness.

 

unseated from motherboard.

 

 

 

 

 

921-Device in PCI Express slot failed to

There is an incompatibility/problem with this

Try rebooting the system. If the error

initialize

device and the system or PCI Express Link

reoccurs, the device may not work with this

 

could not be retrained to an x1.

system

 

 

 

 

1151-Serial Port A Address Conflict Detected

Both external and internal serial ports are

1.

Remove any serial port expansion

 

assigned to COM1.

 

cards.

 

 

2.

Clear CMOS.

 

 

3.

Reconfigure card resources and/or run

 

 

 

Computer Setup or Windows utilities.

 

 

 

 

1152-Serial Port B Address Conflict Detected

Both external and internal serial ports are

1.

Remove any serial port expansion

 

assigned to COM2.

 

cards.

 

 

2.

Clear CMOS.

 

 

3.

Reconfigure card resources and/or run

 

 

 

Computer Setup or Windows utilities.

 

 

 

 

1155-Serial Port Address Conflict Detected

Both external and internal serial ports are

1.

Remove any serial port expansion

 

assigned to same IRQ.

 

cards.

 

 

2.

Clear CMOS.

 

 

3.

Reconfigure card resources and/or run

 

 

 

Computer Setup or Windows utilities.

 

 

 

1201-System Audio Address Conflict

Device IRQ address conflicts with another

Enter Computer Setup and reset the IRQ in

Detected

device.

Advanced > Onboard Devices.

 

 

 

 

ENWW

POST Numeric Codes and Text Messages 107