Remove the display assembly:
1.Position the computer
2.Open the computer as far as possible.
CAUTION: Support the display assembly when removing the following screws. Failure to support the display assembly can result in damage to the display assembly and other computer components.
3.Remove the four Phillips PM2.5×4.5 screws (1) that secure the display assembly to the computer.
NOTE: When replacing the display assembly, only replace the four bottom screws. The top screw on each side is replaced when you install the top cover.
4.Lift the display assembly up and off the computer (2).
5.If it is necessary to replace the display bezel, display enclosure, or display hinges, remove the eight rubber screw covers (1) and the eight Phillips PM2.5×6.0 screws (2) that secure the display bezel to the display assembly. The rubber screw covers are available in the Rubber Kit, spare part number
98 Chapter 4 Removal and replacement procedures
