HP FN068UTABA, 4411S, 4410S manual Hard drive

Hard drive

NOTE: The hard drive spare part kit includes a hard drive bracket.

Description	Spare part number
500-GB, 7200-rpm hard drive	575195-001
500-GB, 5400-rpm hard drive	536414-001
320-GB, 7200-rpm hard drive	575194-001
320-GB, 5400-rpm hard drive	536413-001
250-GB, 7200-rpm hard drive	538972-001
250-GB, 5400-rpm hard drive	536412-001
160-GB, 7200-rpm hard drive	538971-001
160-GB, 5400-rpm hard drive	536411-001

Before removing the hard drive, follow these steps:

1.Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system.

2.Disconnect all external devices connected to the computer.

3.Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer.

4.Remove the battery (see Battery on page 63).

5.Remove the following components:

a.Switch cover and keyboard (see Switch cover and keyboard on page 64)

b.Palm rest (see Palm rest on page 75)

Remove the hard drive:

1.Position the computer right-side up with the front toward you.

2.Remove the two Phillips PM2.0×4.0 screws (1) and loosen the Phillips PM2.5×11.0 captive screw

(2) that secures the hard drive to the computer.

3.Grasp the Mylar tab on the hard drive and slide the hard drive (3) to the left to disconnect it from the system board.

78 Chapter 4 Removal and replacement procedures