HP HEWLET VECTRA VA 6/XXX Not attempt to make any adjustment of the laser unit, Screws provided

	2 How to Install Accessories In Your PC
	Installing Mass Storage Devices
	Installing a Flexible Disk Drive, CD-ROM Drive, or Tape Drive
WARNING	To take care to avoid electric shock and harm to your eyes by laser light
	from a CD-ROM drive, do not open the CD-ROM drive enclosure. The
	drive should be serviced by authorized service personnel only. Refer to
	the label on the CD-ROM for power requirements and wavelength. Do
	not attempt to make any adjustment of the laser unit.
	1	Switch off the display and computer, and disconnect the power
		supply cables and any telecommunications cables.
	2	Remove the computer’s cover (see page 13).
	3	If present, remove the small cover plate on the shelf by removing the
		two screws and pulling it out.
	4	Check that the mounting rails are attached to the device with the
		screws provided.
	5	Slide the drive completely into the shelf.
	6	Connect the power and data cables to the rear of the device (the
		connectors are shaped to go in one way only). See “Internal
		Connectors” on page 20 for more information about which
		connectors to use.
	7	Secure the device in position using the screws provided with the
		device.
	8	To allow access to the device, remove the relevant shelf cover plate
		from the cover by pulling the plate from the left and unhinging its
		right-hand side. Store it in a safe place.
	9	Install any other accessories before replacing the cover.

24