Fixing the System

an Infrastructure connection. For more details, see Chapter 2, “Presenting from a Networked Computer,” on page 17 or Chapter 3, “Presenting from a Wireless Handheld Organizer,” on page 29.

If the projector’s network configuration is completely wrong and you cannot fix it:

❏Reset the projector’s network configuration to the factory default values. To do this, turn off the projector, allow it to cool, then unplug the power cord. Then insert a straightened paperclip into the small hole on the module below the audio port. While pressing the small button inside, plug in the power cord and continue holding the button for at least 15 seconds.

❏Contact your network administrator to determine the proper settings for your network.

Setup problems

If you cannot change settings using a Web browser:

❏If you cannot connect to the projector using a Web browser, see the previous problem above.

❏If you cannot access or edit certain pages, the Web interface has been protected by the Web administrator. Contact the administrator.

❏If the administrator password has been forgotten, reset the network configuration to the factory default values. See the previous problem above.

If you cannot install Wireless Presenter-to-Go on your computer:

❏Be sure your computer meets the minimum requirements for Wireless Presenter-to-Go. See “To prepare your computer for networked presentations” on page 18 for more information.

❏If an earlier version of HP Wireless Presenter-to-Go is installed on your computer, try uninstalling it before installing a new version.

56

User’s Guide