
If you installed DECnet Phase IV, see the DECnet for OpenVMS Guide to Networking manual for information about configuring this software using the NETCONFIG command procedure.
Once you have configured DECnet Phase IV, edit
SYS$COMMON:[SYSMGR]SYSTARTUP_VMS.COM so that the software starts when the system reboots. (This step is not required if you are running DECnet Phase V.) You can have the software start interactively or in batch mode by making one of the following changes:
Interactive mode: | Before: |
| $!$ START/NETWORK DECNET |
| After: |
| $ START/NETWORK DECNET |
Batch mode: | Before: |
| $!$ SUBMIT SYS$MANAGER:STARTNET.COM |
| After: |
| $ SUBMIT SYS$MANAGER:STARTNET.COM |
IMPORTANT: If you intend to run both DECnet Phase IV and a TCP product, DECnet must start first. In this case, HP recommends starting DECnet using interactive mode.
For information about editing
7.7.5 Configuring HP TCP/IP Services for OpenVMS
If you plan to run TCP/IP Services for OpenVMS software, note the following:
•Configure your system for networking by executing the interactive command procedure SYS$MANAGER:TCPIP$CONFIG.COM. Be sure to consult the HP TCP/IP Services for OpenVMS Installation and Configuration manual for specifics about configuring TCP/IP Services for OpenVMS and for configuring IPv6 support.
•After completing the configuration, edit the command pertaining to TCP/IP Services for OpenVMS in SYS$COMMON:[SYSMGR]SYSTARTUP_VMS.COM (as instructed in Section 7.16 (page 143)) so that the TCP/IP Services software starts automatically when your system is rebooted.
IMPORTANT: Do not configure TCP/IP Services for OpenVMS without first starting the queue manager.
7.7.6 Installing and Configuring Third-Party Networking Software
You need networking software to download patches and as a requirement for certain layered products. If you are using neither DECnet nor TCP/IP Services for OpenVMS, you should install and configure
7.8 Initializing or Configuring Other Installed Components
Initialize or configure any of the following products as necessary, following the instructions in the sections indicated:
•CDSA (Section 7.8.1 (page 123))
•Availability Manager (Section 7.8.2 (page 124))
•Kerberos (Section 7.8.3 (page 125))
•SSL for OpenVMS (Section 7.8.4 (page 126))
122 After Installing or Upgrading the OpenVMS Operating System