HP OpenVMS 8.x manual $ Run Sys$Sysrootwbemserviceswbemservices$Config

NOTE: HP recommends that you do not remove the WBEM Services for OpenVMS product even if you do not have a need for it. If you attempt to use the PRODUCT REMOVE command to remove this product, you might see a message similar to the following. This message is automatically displayed for any product that is required with OpenVMS. The consequences of removing WBEM Services for OpenVMS might not be as severe as implied by the message unless other software is using the product on your server.

%PCSI-E-HRDREF, product HP I64VMS WBEMCIM V2.61 is referenced by HP I64VMS OPENVMS V8.3-1H1

The two products listed above are tightly bound by a software dependency. If you override the recommendation to terminate the operation, the referenced product will be removed, but the referencing product will have an unsatisfied software dependency and may no longer function correctly. Please review the referencing product’s documentation on requirements.

Answer YES to the following question to terminate the PRODUCT command. However, if you are sure you want to remove the referenced product then answer NO to continue the operation.

Terminating is strongly recommended. Do you want to terminate? [YES]

7.8.5.1Configuring WBEM Services for OpenVMS (Where Not Configured Previously)

To configure WBEM Services for OpenVMS on a system for the first time, follow these steps:

1.Enter the following command

$ RUN SYS$SYSROOT:[WBEM_SERVICES]WBEM_SERVICES$CONFIG

This command invokes the utility that configures and initializes the environment for WBEM Services for OpenVMS.

2.After displaying the initial configuration utility banner, the utility informs you where it will store the configuration files and repository and asks if you want to change the location.

The configuration files and repository will be placed in the following location: SYS$SPECIFIC:[WBEM_Services].

Do you want to change this location (Yes/No) [No]?:

NOTE: The repository, a compiled version of the Common Information Model (CIM) class schema, requires an ODS-5 formatted disk (the repository uses UNIX-style file names, which are not supported on ODS-2 formatted disks). If the default location is on an ODS-2 formatted disk, you must change the location to an ODS-5 disk.

When you accept the default location, the utility informs you that all configuration questions have been answered and asks whether you want to continue, as shown in the following example. If you choose to continue, the utility creates the CIMServer repository tree in the location indicated earlier. The CIMServer is the WBEM Services for OpenVMS process that runs on the system to support certain applications. It also creates the following command files:

SYS$STARTUP:WBEM_Services$Startup.com

SYS$STARTUP:WBEM_Services$Shutdown.com

SYS$SYSROOT:[WBEM_SERVICES]WBEM_Services$Define_Commands.com

The SYS$STARTUP:WBEM_Services$Startup.com file defines system logicals for the WBEM Services for OpenVMS environment.

All configuration questions have been answered.

128 After Installing or Upgrading the OpenVMS Operating System