HP Pro 110 manual Post Numeric Codes and Text Messages, Device Options NIC PXE Option

POST Numeric Codes and Text Messages

This section covers those POST errors that have numeric codes associated with them. The section also includes some text messages that may be encountered during POST.

NOTE: The computer will beep once after a POST text message is displayed on the screen.

Table A-1Numeric Codes and Text Messages

Control panel message	Description	Recommended action
101-Option ROM Checksum Error	System ROM or expansion board option	1.	Verify the correct ROM.
	ROM checksum.	2.	Flash the ROM if needed.
		3.	If an expansion board was recently
			added, remove it to see if the problem
			remains.
		4.	Clear CMOS.
		5.	If the message disappears, there may
			be a problem with the expansion card.
		6.	Replace the system board.
103-System Board Failure	DMA or timers.	1.	Clear CMOS.
		2.	Remove expansion boards.
		3.	Replace the system board.
110-Out of Memory Space for Option ROMs	Recently added PCI expansion card	1.	If a PCI expansion card was recently
	contains an option ROM too large to		added, remove it to see if the problem
	download during POST.		remains.
		2.	In Computer Setup, set Advanced >
			Device Options > NIC PXE Option
			ROM Download to DISABLE to
			prevent PXE option ROM for the
			internal NIC from being downloaded
			during POST to free more memory for
			an expansion card's option ROM.
			Internal PXE option ROM is used for
			booting from the NIC to a PXE server.
162-System Options Not Set	Configuration incorrect.	Run Computer Setup and check the
	RTC (real-time clock) battery may need to	configuration in Advanced > Device
		Options.
	be replaced.

Reset the date and time under Control Panel. If the problem persists, replace the RTC battery. See the Hardware Reference Guide for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement.

163-Time & Date Not Set	Invalid time or date in configuration
	memory.
	RTC (real-time clock) battery may need to
	be replaced.

Reset the date and time under Control Panel (Computer Setup can also be used). If the problem persists, replace the RTC battery. See the Hardware Reference Guide for instructions on installing a new battery, or contact an authorized dealer or reseller for RTC battery replacement.

66 Appendix A POST Error Messages