2.Connect the Ethernet cable to the Ethernet port on the back of the HP All-in-One.

3.Connect the other end of the Ethernet cable to an available port on your Ethernet router, switch, or wireless router.

4.Once you have connected the HP All-in-One to the network, install the software as described in the next section.

Install the software for a network connection

Use this section to install the HP All-in-One software on a Windows or Mac computer connected to a network. Before you install the software, make sure you have connected the HP All-in-One as described in the previous section.

Note 1 If your computer is configured to connect to a series of network drives, make sure that your computer is currently connected to these drives before installing the software. Otherwise, HP All-in-One installation software might try to use one of the reserved drive letters, and you will not be able to access that network drive on your computer.

Note 2 Installation time can range from 20 to 45 minutes depending on your operating system, the amount of available space, and the processor speed of your computer.

To install the Windows HP All-in-One software

1.Quit all applications running on your computer, and any firewall or virus detection software.

2.Insert the Windows CD that came with the HP All-in-One into the CD-ROM drive on your computer and follow the onscreen instructions.

setup Finish

User Guide

31