5.Clean the glass strip with a soft cloth or sponge slightly moistened with a nonabrasive glass cleaner.

Caution Do not use abrasives, acetone, benzene, or carbon tetrachloride on the glass, since they can damage it. Do not place or spray liquid directly on the glass. The liquid might seep under the glass and damage the device.

6.Lower the automatic document feeder mechanism, and then close the cover of the automatic document feeder.

7.Close the lid.

8.Plug in the power cord, and then turn on the HP All-in-One.

Clean the lid backing

Minor debris can accumulate on the white document backing located underneath the lid of the HP All-in-One.

To clean the lid backing

1.Turn off the HP All-in-One, unplug the power cord, and raise the lid.

Note Depending how long the HP All-in-One is unplugged, the date and time might be erased. You might need to reset the date and time later, when you plug the power cord back in.

2.Clean the white document backing with a soft cloth or sponge slightly moistened with a mild soap and warm water.

Wash the backing gently to loosen debris. Do not scrub the backing.

3.Dry the backing with a chamois or soft cloth.

Caution Do not use paper-based wipes, as these might scratch the backing.

4.If further cleaning is needed, repeat the previous steps using isopropyl (rubbing) alcohol, and wipe the backing thoroughly with a damp cloth to remove any residual alcohol.

Caution Be careful not to spill alcohol on the glass or exterior of the

HP All-in-One, as this might damage the device.

One-in-All HP the Maintain

User Guide

93