UPS frequently switches between utility and battery power

Action:

1.Check the input voltage and reconfigure the UPS ("Configuring the UPS" on page 28).

2.Contact a qualified electrician to verify that the utility power is suitable for the UPS.

UPS is in Auto-Bypass mode

Action:

1.If power management software is being used, check the log files to obtain specific error information to help identify the problem.

For more information about the causes of a general fault condition, see the HP Power Manager user guide available for download from the HP website (http://www.hp.com/go/rackandpower).

2.Verify that no blockage of airflow to the front bezel and rear panel exists.

3.If the LED does not turn off, replace the electronics module. ("Replacing the UPS electronics module" on page 33)

UPS is on battery

Action: Save files and shut down connected equipment.

Utility power condition

The utility input voltage is outside the operating range.

Action:

1.Check the input voltage and reconfigure the UPS ("Configuring the UPS" on page 28).

2.Contact a qualified electrician to verify that the utility power is suitable for the UPS.

Troubleshooting 43