HP rx1620 manual Removing a Processor, Processor Location

Figure 29 Processor Location

WARNING! Ensure that the system is powered-down and all power sources have been disconnected from the server prior to removing or replacing a processor.

Voltages are present at various locations within the server whenever an AC power source is connected. This voltage is present even when the main power switch is in the off position.

Failure to observe this warning could result in personal injury or damage to equipment.

CAUTION: Failure to properly complete the steps in this procedure will result in erratic system behavior or system failure. For assistance with this procedure, contact your local HP Authorized Service Provider.

Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD safety precautions could result in damage to the server.

Avoid contact with the processor heatsink if the server has been operating prior to the installation of the additional processor. The heatsink will be safe to touch after the cover has been removed for a few seconds.

Removing a Processor

To remove a processor, perform the following steps:

1.Turn off the system and disconnect all cables.

2.Remove the cover. See “Removing and Replacing the Cover” (page 30).

3.Remove the sheet metal air duct.

4.Disconnect the power pod cable from the power connector on the system board.

34 Removing and Replacing Components