3.Install the spring-loaded clamp’s dowels (A and B below) into the reflector. Figure 9-9Installing the dowels into the reflector

4.Repeat this procedure for the other lamp.

Re-install the lamp housings

Re-install the user-end lamp housing

1.Secure the lamp housing to the lamp assembly using the original two lower silver screws on the user end of the carriage (see screws A in Figure 9-3 User end screws on page 61 for locations).

●If you have difficultly fitting the lamp housing back onto the lamp base, loosen the four screws indicated below.

●If the lamp housing is still difficult to install, squeeze the side of the lamp base to bend the side in about 0.8 mm (0.031 in).

Figure 9-10Loosening screws to ease installation

ENWW

Replace UV lamp bulb (500–1000 hours) 65