HP Serviceguard Extension for RAC (SGeRAC) manual Status After Package Switching is Enabled

Alternate	up	enabled	ftsys9	(current)
NODE	STATUS	STATE
ftsys10	up	running
Network_Parameters:
INTERFACE	STATUS	PATH	NAME
PRIMARY	up	28.1	lan0
STANDBY	up	32.1	lan1

Now pkg2 is running on node ftsys9. Note that it is still disabled from switching.

Status After Package Switching is Enabled

The following command changes package status back to Package Switching Enabled:

#cmmodpkg -e pkg2

The output of the cmviewcl command is now as follows:

CLUSTER STATUS

example up

NODE	STATUS	STATE
ftsys9	up	running
PACKAGE	STATUS	STATE	AUTO_RUN	NODE
pkg1	up	running	enabled	ftsys9
pkg2	up	running	enabled	ftsys9
NODE	STATUS	STATE
ftsys10	up	running

Both packages are now running on ftsys9 and pkg2 is enabled for switching. Ftsys10 is running the daemon and no packages are running on ftsys10.

Status After Halting a Node

After halting ftsys10, with the following command:

#cmhaltnode ftsys10

the output of cmviewcl is as follows on ftsys9:

CLUSTER STATUS

example up

NODE	STATUS	STATE
ftsys9	up	running
PACKAGE	STATUS	STATE	AUTO_RUN	NODE
pkg1	up	running	enabled	ftsys9
pkg2	up	running	enabled	ftsys9
NODE	STATUS	STATE
ftsys10	down	halted

This output is seen on both ftsys9 and ftsys10.

Viewing Data on Unowned Packages

The following example shows packages that are currently unowned—not running on any configured node. Information on monitored resources is provided for each node. This information allows you to identify the cause of a failure and decide where to start the package up again.

UNOWNED_PACKAGES

PACKAGE	STATUS	STATE	AUTO_RUN	NODE
PKG3	down	halted	enabled	unowned

Reviewing Cluster and Package States with the cmviewcl Command 121