Setup Menus

Font

This enables you to specify the font to be used for displaying characters. The available settings depend on the fonts installed.

Numeral Swap

Factory default: Unselected

When using a code page that supports a bilingual keyboard, this will cause all numbers to be displayed using the National character set when in Latin mode.

Symbol Swap

Factory default: Unselected

Selecting this option will cause symbols such as brackets to be displayed the correct way round when typing in right-to-left mode.

Keyboard Type

The settings of the Keyboard Type, SBCS and DBCS options below will reflect the default settings for the chosen language and should only be changed by the System Administrator. If they have been changed and you wish to restore the default settings in this dialog box, click the Default button.

Unlock Delay

Factory default: 0

When the keyboard is unlocked by the host, this specifies a delay in milliseconds before characters are sent.

SBCS & DBCS

The Single Byte Character Set (and Double Byte Character Set if supported) options enable you to change the settings used by default for the chosen language. These should only be changed by the System Administrator. If they have been changed and you wish to restore the default settings in this dialog box, click the Default button. The following table shows the default settings. A list of IBM EBCDIC codepages supplied can be found at the end of the Character Sets appendix.

If double byte character sets (e.g. Japanese) are supported and you wish to use them, then set the IBM 5250 Model to either 5555_B01 (monochrome) or 5555_C01 (colour) for display, or 5553-B01for printing.

5-47