Setup Menus

Selecting End on Non-Hexenables you to specify the number of characters that make up the end sequence in the End Length box. The bypass will then terminate as soon as a non-hexadecimal character is received (any character except in the range 0 through 9 and A through F) followed by the end sequence.

Characters can be entered in several ways. For example, to specify the ASCII escape character, you can enter either _027, \u001B, \e, \033, or even ^[.

Font

This enables you to specify the font to be used for displaying characters. The available settings depend on the fonts installed.

SBCS, APL2 & DBCS

The Single Byte Character Set, APL2 and Double Byte Character Set options enable you to change the settings used by default for the chosen language. These should only be changed by the System Administrator. If they have been changed and you wish to restore the default settings in this dialog box, click the Default button. The following table shows the default settings. A list of IBM EBCDIC codepages supplied can be found at the end of the Character Sets appendix.

Note: Double byte character sets may not be supported by this version of the emulator.

5-41