IBM 5250 Emulation

3487_HC

Colour

24 x 80

5555_B01

Monochrome

24 x 80

5555_C01

Colour

24 x 80

The printer models supported are listed below:

3812-1

Single byte printer

5553-B01

Double byte printer

If double byte character sets (e.g. Japanese) are supported and you wish to use them, then select either 5555_B01 (monochrome) or 5555_C01 (colour) for display, or 5553-B01for printing.

5.Specify the Monochrome setting. Note that all IBM 5250 models support both monochrome and colour display. When monochrome is selected, characters will be displayed in green and intense fields will be displayed in white. When mono- chrome is not selected, the settings specified in the Attributes dialog box (de- scribed in the Setup Menus chapter) will be used for the display.

Click OK to close the dialog box.6.Select Save Session in the File menu.

7.Select New Connection in the File menu to display the New Connection dialog box.

8.Select the type of host connection required in the Type list box.

For a TCP/IP connection, select TCP/IP, enter the name or internet address of the host computer in the Connect To box, then click Configure for additional Telnet options. Refer to the TCP/IP Connection Settings section in chapter 2 for details.

For a modem connection, select Modem, specify the communications port in the Connect To box, then click Configure to display configuration options. Refer to the Modem Connection Settings section in chapter 2 for details.

For a serial connection, select Serial, specify the communications port in the Connect To box, then click Configure for additional serial options. Refer to the Serial Connection Settings section in chapter 2 for details.

9.When you have specified the required settings in the New Connection dialog box, click the Connect button to make the connection.

10.If necessary, enter the appropriate information to establish an IBM host session in the Network Virtual Terminal mode screen.

11.When an IBM host session has been established, the screen will switch out of Network Virtual Terminal mode and display the IBM 5250 emulation screen.

Note: You will be returned to the Network Virtual Terminal screen when the connection to the IBM host has been closed.

10-4