HP Thin Client t5500 Initialization Commands, NAME, Startup,NAME, Startup,Default, Initialization Commands, HKLM\Software\Pericom\<product name

Initialization Commands

14

Initialization Commands

This chapter describes all the initialization commands that can be included in the registry or on the command line to run the emulator.

Introduction

This chapter describes the registry entries and command line options that can be used to specify how the emulator is initially run.

Registry entries for the emulator are read from a registry key under HKLM\Software\Pericom\<product name> using Startup,Default or Startup,NAME (where NAME is specified using the -Ncommand line option).

Command line options are used to modify the configuration of the emulator on start- up. They are entered after the name of the emulator and each option must be preceded by a space. An option is immediately followed by its setting if one is required, without a space in between.

The following section provides a summary of all the registry entries and command line options supported by the emulator. This is followed by sections describing the commands in detail, grouped according to their function.

14-1