Setup Menus

The WYSE PCTerm emulation provides compatibility with software designed for the PC Term personality supported by Wyse. Keyboard scan codes are sent on key press/ release instead of ASCII codes by default.

The WY50, WY50+ and WY60 emulations provide compatibility with software designed to drive the Wyse WY-50, WY-50+ and WY-60 terminals, respectively. Refer to the Wyse Emulations chapter for information on these emulations.

VT Terminal ID

Factory default: VT420

This specifies what is reported back to the host in response to a terminal identification request. You can either select from the list of IDs or you can edit the text box and enter a different terminal identity. (Note that not all features of the specified terminal may be supported.)

National

Factory default: Unselected

This will only be available if the system is configured for a language that supports national replacement character sets.

The setting of this option determines the type of character set used to generate characters. When selected, a character set specific to the selected keyboard nationality is used. When unselected (default) the emulator is in Multinational mode, a character set consisting of two tables of characters is used. This enables characters from any keyboard nationality to be generated.

Tertiary Device Attribute

When the emulator is in VT420 mode (Emulation set to VT500 and Terminal ID set to VT420), this option enables you to specify the tertiary device attribute report that is sent in response to a request from the host.

Answerback String

This option enables you to specify the Answerback string that is sent to the host in response to an ANSI mode enquiry command. The string may be up to 30 characters long.

Answerback Concealed

Factory default: Unselected

Selecting this option will cause the Answerback string specified in the text box above to be locked from change and displayed as asterisks. Note that deselecting this option will cause the Answerback string to be deleted.

5-21