Installing HP DCE 1.7
Loading HP DCE Software in a Network Source Area
Loading HP DCE Software in a Network Source Area
Before installation of HP DCE/9000 Version 1.7 software on a network, the software typically is transferred from the media on which it was shipped to a network source area, or depot. This section tells how to perform this transfer using the swcopy tool.
Before loading HP DCE, you should be aware of the following:
•If you are installing HP DCE/9000 on a single system, and your system has access to a media device, you can choose to install software directly from media. If you want to do this, proceed to “Installing Software” in this chapter.
•If your software was shipped with a codeword certificate, you must obtain a codeword from
Software Loading Procedure
This section outlines the steps you must follow to load HP DCE 1.7 software into a network source area using the swcopy graphical or textual user interface.
See Managing
Perform the following steps to load HP DCE 1.7 software into a network source area:
1.Load media into the drive.
2.Log in as root.
3.Start /usr/sbin/swcopy.
4.Specify the target depot path in the “Select Target Depot Path” popup window.
Planning and Configuring HP DCE 1.7 |