Migrating to HP DCE 1.7

Migrating an HP DCE 1.4 Server on HP-UX 10.01 to HP DCE 1.7 on HP-UX 11.0

Migrating an HP DCE 1.4 Server on HP-UX 10.01 to HP DCE 1.7 on HP-UX 11.0

This section describes the procedure for migrating an HP DCE 1.4 server on HP-UX 10.01 to HP DCE 1.7 on HP-UX 11.0.

See Managing HP-UX Software with SD-UX and the swcopy (1M), swinstall (1M) and swremove (1M) man pages for complete information on all aspects of HP-UX installation.

For information about migrating from HP-UX 10.x to HP-UX 11.0, see Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 (B2355-90153).

Migration Procedures

HP highly recommends that you do a system backup before starting to do an update.

Migrating a System Without Retaining Cell Configuration

If you are migrating an HP DCE 1.4 server on HP-UX 10.01 to HP DCE

1.7on HP-UX 11.0, but you do not want to preserve your existing cell configuration:

1.Stop the cell using dce_config STOP at each cell member or run DCM from SAM to stop the entire cell.

2.Use dce_config REMOVE or run the DCE Configuration Manager from SAM to remove the cell databases.

3.Upgrade the system from HP-UX 10.01 to HP-UX 11.0.

4.Install HP DCE 1.7 server software as described in Chapter 4, and reconfigure DCE.

Migrating a System and Preserving Current Cell Configuration

If you are migrating an HP DCE 1.4 server on HP-UX 10.01 to HP DCE

1.7on HP-UX 11.0, and you want to preserve your existing cell configuration, perform the following steps:

Planning and Configuring HP DCE 1.7

2-11