CAUTION

NOTE

Migrating to HP DCE 1.7

Migrating an HP DCE 1.6 Server on HP-UX 10.30 to HP DCE 1.7 on HP-UX 11.0

1.If you are migrating a security server system, stop secd using the dcecp -c registry stop replica-namecommand.

2.Stop DCE on the system, using the dce_config STOP command from the main menu; DFS will not run on HP DCE 1.6 or 1.7; if DFS is running, ignore any warnings concerning running processes.

Hewlett-Packard recommends that you create a single network source area (depot) containing HP-UX 11.0 and HP DCE 1.7 software, so you can simultaneously install HP-UX 11.0 and HP DCE 1.7. If you do not install HP-UX 11.0 and HP DCE 1.7 at the same time, your old HP DCE

1.6servers will be automatically started when your system reboots after HP-UX 11.0 installation completes. This is an unsupported configuration.

3.Prepare the network source area (depot) using swcopy. The depot should contain both HP-UX 11.0 and HP DCE 1.7 software.

4.Upgrade the system from HP-UX 10.30 to HP-UX 11.0. If you installed from a unified network source area as recommended above, installation of HP DCE 1.7 is complete.

If you did not install from a unified network source area, you must continue with Steps 5 through 7.

5.Perform this step only if you did not install HP-UX from a unified network source area as recommended above.

Stop DCE on the system, using the dce_config STOP command from the main menu.

6.Perform this step only if you did not install HP-UX from a unified network source area as recommended above.

Install HP DCE 1.7 as described in Chapter 4.

7.Perform this step only if you did not install HP-UX from a unified network source area as recommended above.

Restart DCE using the dce_config START command from the dce_config main menu or using DMC.

2-18

Planning and Configuring HP DCE 1.7