PPTP Configuration

Table 7–9: VPN: PPTP Server Configuration Parameters (Continued)

 

 

Parameter

Description

 

 

 

 

PPTP

Determines how IP addresses are allocated to clients connected through the

Addresses

PPTP server:

 

• Select IP address assigned by RADIUS to enable the device to use the

 

RADIUS server to assign the PPTP client IP address. The RADIUS server must

 

be enabled on the RADIUS page (Authentication > RADIUS).

 

• Specify IP Address Group and select an existing address group to enable the

 

device to assign the PPTP client an IP address from the addresses included in

 

the IP Address group. Use the IP Addresses page (Network > Configuration >

 

IP Address Groups) to create IP Address Groups.

 

 

Note If PPTP Server is disabled, the table is not displayed and the message PPTP Server is currently disabled is displayed.

Enable PPTP Server and Configure PPTP Client and Addresses

STEP 1

STEP 2 STEP 3

STEP 4

STEP 5

STEP 6

STEP 7

STEP 8

If you are not using RADIUS to assign IP addresses, create an IP address group (Network > Configuration > IP Address Groups) containing the pool of IP addresses that the X family device will use to allocate IP addresses to L2TP VPN clients.

Select VPN > PPTP Status. Then click the PPTP Server Configuration tab.

On the PPTP Server Configuration page, check Enable PPTP Server.

This allows VPN clients to use the device as a VPN terminator for PPTP.

Select the remote security zone on which to terminate the VPN from the PPTP security zone drop-down lists.

If you want to use Microsoft Point-to-Point Encryption, check Require encryption. This provides additional security, and is supported by Windows VPN clients.

If you are using Microsoft Networking, enter the IP addresses of your primary and secondary WINS servers in the WINS Server 1 and WINS Server 2 fields respectively.

To configure your DNS Servers, either:

Select Device Acts as DNS Relay if you want the device to act as a proxy-DNS server (DNS relay), passing DNS queries to its configured DNS servers

Select Specify DNS Server and enter up to two local DNS server IP addresses, in the order in which they are to be accessed, in the DNS Server fields

To assign PPTP IP Addresses, either:

Select IP Address Assigned by RADIUS, if you want the device to use the RADIUS server to assign the PPTP client IP address.

Select IP Address Group and select an existing group from the drop-down list, if you want the device to use an IP address group for the client.

STEP 9 Click Apply to save the changes.

X Family LSM User’s Guide V 2.5.1

215