Contents
Inground System Owners Manual
Customer Service Center
Toll-Free Customer Service Number for U.S For Canada
N53 W24700 South Corporate Circle Sussex, WI 53089 U.S.A
BEFORE YOU START
Owner must ensure that all players know and follow
these rules for safe operation of the system
Do not slide, climb, shake or play on pole
SAFETY INSTRUCTIONS
HEIGHT ADJUSTMENT
P/N 21145507 02/04
Remove all contents from boxes
NOTICE TO ASSEMBLERS
PARTS LIST - See Hardware Identifier
Item #36
HARDWARE IDENTIFIER BOLTS & SCREWS
Item #23 Item #8 Item #27 1 Item #16 Item #12 Item #24 Item #31
HARDWARE IDENTIFIER NUTS & WASHERS
2 Socket Wrenches and Sockets 1/2” 9/16” AND
SECTION A ASSEMBLE THE POLE
2 1/2”, 2 9/16” AND 2 3/4” Wrenches AND/OR
a Phillips-Head Screwdriver
CONTACT UTILITIES BEFORE DIGGING
MIDDLE
BOTTOM
Tape Not Supplied
FLANGE
FIG. A
FIG. B FIG. C
SIDE VIEW
Note B
SIDE VIEW
Note A
Note A
7. Install ground sleeve cap 5 onto
10. Attach spacers 10, 11 to pole mount bracket 7 with bolts 12, washers 13, and nuts 14 as shown. IMPORTANT! Tighten until washers 13 no longer move
to prevent labels from being damaged during height adjustment
SIDE ACCESS
Indicator labels should be applied as close to holes as possible as
20 shown in illustration
2 1/2, 2 9/16” AND 2 3/4” Wrenches AND/OR
SECTION B ASSEMBLE THE BACKBOARD TO ELEVATOR TUBES
ASSEMBLY WILL VARY DUE TO BACKBOARD STYLE
2 Socket Wrenches and Sockets
1B. Assemble elevator tubes 30 as shown. Tighten completely
2B. Assemble elevator tubes 30 as shown. Tighten completely
Use the following assembly instructions if you have a
48 molded plastic backboard Fan
02/04
Instructions Included With Backboard Hardware For Board Assembly
a 44” steel-framed acrylic backboard
Use the following assembly instructions if you have a
3A. Assemble backboard brackets to board as shown Refer To
Instructions
Assembly
Refer To
Included With Rim
48” molded plastic-framed acrylic backboard
Use the following assembly instructions if you have a
Install spacers 25, and springs 39 onto backboard
2 3/4” Wrenches AND/OR 2 Socket Wrenches and Sockets
SECTION C ATTACH THE BACKBOARD/ELEVATOR TO POLE SYSTEM
BACKBOARD WILL VARY
3/4”
17. Install handle assembly to long
USE EYE PROTECTION WHEN INSTALLING SPRINGS
WAIT A MINIMUM OF 24 HOURS BEFORE GOING ON TO NEXT STEP22
CONCRETE MUST CURE
Page
NET INSTALLATION
Insert net into bottom of clip as shown
02/04
IMPORTANT! The elevator holes MUST be parallel with playing surface
Note A
NOTE A Do not use washers here on spring return style rim
NOTE A Do not use washers here on spring return style rim
Note A
B. Move elevator up or down to desired height
B C A
25. A. While holding handle, remove pin
C. Replace pin 26 full length to lock system at desired height
