DW6000 LED operation
This section describes the LEDs’ appearance during typical DW6000 operation. Refer to Figure 11 for the LED’s locations.
Note: If the Power LED blinks, the DW6000 is running the fallback.bin. This will usually happen when the unit is first installed. The unit may run the fallback.bin if the main.bin does not successfully load; in this case, power cycle the unit.
Normal operation When the DW6000 is powered on and transmitting or receiving data:
•The LAN LED is on. The LED blinks off momentarily when frames are transmitted or received.
•The Transmit LED is on. The LED blinks off momentarily when frames are transmitted.
•The Receive LED is on. The LED blinks on momentarily when frames are received.
•The System LED is on.
•The Power LED is on.
Ethernet port LED The DW6000 Ethernet LAN link has two indicators on the rear of the unit on the operation top of the LAN port. The green indicator shows link status. The yellow indicator
shows traffic speed. Figure 17 illustrates the Ethernet link LEDs.
Traffic speed indicator LED (yellow)
On = 100BaseT
Off = 10BaseT
Link traffic
indicator LED (green)
Flashing green = valid link
Off = no valid link
Figure 10: Ethernet port LED operation
16 DW6000 LEDs Operation
