When there is no A/V receiver available | Humax HDCI-2000 instruction

2. When there is no A/V receiver available

In case you are not equipped with an A/V receiver, connect the product to the TV using the audio cable as follows.

Note: You can also connect the product to the audio input jack of your TV set using the 3.5 Stereo Jack Cable to 2 RCA Y Cable.

GB 15

Image 16

Humax HDCI-2000 manual When there is no A/V receiver available

Contents

Page Copyright Copyright 2007 Humax Corporation Meaning of Symbols Safety and Warning Safety Instructions and Precautions Replacement of Parts To avoid damage of the power cord or plugLIGHTNING, STORM, or not in USE To avoid electrical shock Contents Installation Software UpdateMenu Map Trouble Shooting Specification Glossary Service and Support Before Using the Product Package Contents Front Panel P + Button Conditional Access Inserting a CI with Smartcard Rear Panel RS-232C Remote Control 17.V- / V+ 16.OKInformation Setup Using Hdmi Connector Using DVI Connector When equipped with an A/V receiver When there is no A/V receiver available Using Component Cable Using Scart Cable Powering On Language Installation WizardSearch Channel Installation Wizard Software Update Time Switching Channel Volume ControlBasic Operation Lip-Sync Option List ResolutionAudio Teletext Subtitle Programme Information i- plate General Information Detailed Programme Information Channel List All Channel List Deleting Channels Renaming Channels Including Channels in Favourite Group Configuring Menu Using Lock/UnlockFavourite List Satellite List Scramble List EPG Using EPGEPG Main Channel List Reserving ProgrammesNUMERIC0-9 buttons Schedule List EPG TableModifying Schedule Find Programme Deleting ScheduleNew Reservation Choosing Genre Search by Time Entering Programme NameSearch by Day of Week Search Result CI-Module SystemSystem Status TV Screen Format PictureDisplay Format Dolby Digital Scart SignalAV Control Startup-Channel Setting the Startup-ChannelStartup-Channel Parental Control SettingCensorship Classification Change Password Installation Lock Menu Language Language SettingSubtitle Display Subtitle Font Time SettingGMT Offset Power On Power Off A/V Setting Audio Output Display Time Other SettingsOSD Transparency Edit Channels Edit Channels Locking/Unlocking Channels Moving Channels Selecting a Channel Group Select/Unselect All Channels Edit Favourite List Renaming Favourite Groups Selecting Favourite Groups Moving Favourite ChannelsSelecting/Unselecting All Channels Adding/Removing Channels Search Channels InstallationFixed Antenna Satellite LNB Frequency22KHz Tone DiSEqC Input Motor Antenna Motor Type My Longitude My Latitude Enable Channel search is available Disable Edit Satellite DataActivate Satellite Satellite Longitude Motor Setting Transponder Motor DrivingContinuous Motor moves continuously Step Time Motor moves during specified Store Current Position Go to Stored PositionRecalculate Installer Menu Motor LimitLimit Position Set Limit Reset Position TransponderFrequency Polarization Transmission Symbol RateModulation Scrambled Type Network SearchChannel Type Search Result Advanced Search Antenna Video PID Audio PID Smatv Automatic Search Smatv SearchStart/End Frequency Smatv Manual Search Automatic Update Manual Update Polarisation Default Setting Press the OK or Back button Software Update OTA Over the Air New software is found when powering on Mandatory Update Menu Map Trouble Shooting Trouble ShootingNo picture on TV set Poor picture/sound quality Remote control does not operate No password information is givenCannot update new software No or poor sound Error Message Error message Possible causes What to do Specification Tuner & Channel Audio/Video/Data In/Out Glossary Qpsk Quaternary Phase Shift Keying PID Packet IdentifierSmartcard Pdif Sony/Philips Digital Interface format Service and Support Italy Tel Sweden TelFinland Tel Opening Hours Austria Tel