Powering On | Humax HDCI-2000 guide

2. Setup

2.5Powering On

1.Connect the power cord of the product to a wall outlet.

2.Turn on the power switch located at the left side on the back of the product.

3.Power on by pressing the STANDBY button of the remote control or the STANDBY button at the front of the product.

GB 18

Image 19

Humax HDCI-2000 manual Powering On

Contents

Page Copyright Copyright 2007 Humax Corporation Meaning of Symbols Safety Instructions and Precautions Safety and Warning To avoid electrical shock Replacement of PartsTo avoid damage of the power cord or plug LIGHTNING, STORM, or not in USE Contents Specification Glossary Service and Support InstallationSoftware Update Menu Map Trouble Shooting Package Contents Before Using the Product P + Button Front Panel Inserting a CI with Smartcard Conditional Access RS-232C Rear Panel Remote Control 17.V- / V+ 16.OKInformation Using Hdmi Connector Setup When equipped with an A/V receiver Using DVI Connector When there is no A/V receiver available Using Component Cable Using Scart Cable Powering On Language Installation WizardSearch Channel Installation Wizard Time Software Update Lip-Sync Switching ChannelVolume Control Basic Operation Option List ResolutionAudio Subtitle Teletext General Information Programme Information i- plate Detailed Programme Information All Channel List Channel List Renaming Channels Deleting Channels Including Channels in Favourite Group Configuring Menu Using Lock/UnlockFavourite List Scramble List Satellite List EPG Using EPGEPG Main Channel List Reserving ProgrammesNUMERIC0-9 buttons Schedule List EPG TableModifying Schedule Choosing Genre Find ProgrammeDeleting Schedule New Reservation Search by Time Entering Programme NameSearch by Day of Week Search Result CI-Module SystemSystem Status TV Screen Format PictureDisplay Format Dolby Digital Scart SignalAV Control Startup-Channel Setting the Startup-ChannelStartup-Channel Parental Control SettingCensorship Classification Installation Lock Change Password Menu Language Language SettingSubtitle Display Subtitle Font Time SettingGMT Offset Power Off Power On Audio Output A/V Setting Display Time Other SettingsOSD Transparency Edit Channels Edit Channels Moving Channels Locking/Unlocking Channels Select/Unselect All Channels Selecting a Channel Group Renaming Favourite Groups Edit Favourite List Selecting Favourite Groups Moving Favourite ChannelsSelecting/Unselecting All Channels Adding/Removing Channels Search Channels InstallationFixed Antenna DiSEqC Input SatelliteLNB Frequency 22KHz Tone Motor Type Motor Antenna My Latitude My Longitude Satellite Longitude Enable Channel search is available DisableEdit Satellite Data Activate Satellite Time Motor moves during specified Motor SettingTransponder Motor Driving Continuous Motor moves continuously Step Store Current Position Go to Stored PositionRecalculate Set Limit Installer MenuMotor Limit Limit Position Polarization Reset PositionTransponder Frequency Transmission Symbol RateModulation Scrambled Type Network SearchChannel Type Search Result Antenna Advanced Search Audio PID Video PID Smatv Automatic Search Smatv SearchStart/End Frequency Smatv Manual Search Manual Update Automatic Update Polarisation Press the OK or Back button Default Setting OTA Over the Air Software Update Mandatory Update New software is found when powering on Menu Map Poor picture/sound quality Trouble ShootingTrouble Shooting No picture on TV set No or poor sound Remote control does not operateNo password information is given Cannot update new software Error message Possible causes What to do Error Message Tuner & Channel Specification Audio/Video/Data In/Out Glossary Pdif Sony/Philips Digital Interface format Qpsk Quaternary Phase Shift KeyingPID Packet Identifier Smartcard Service and Support Austria Tel Italy TelSweden Tel Finland Tel Opening Hours