Manuals / Brands / Computer Equipment / Switch / Humminbird / Computer Equipment / Switch

Humminbird 531906-1EN_A A. Two 700 Series™ Units, B.One 700 Series™ Unit & One 800/900/1100 Series™ Unit, 2.Connect the AS EC 10E to each round connector on the AS EC QDE cables

1 43

Download 43 pages, 2.07 Mb

700 Series™ Quick Disconnect Mount Cable Collector

Ethernet

A. Two 700 Series™ Units

1.Insert the AS EC QDE Ethernet cable connector into the Ethernet slot on the 700 Series™ cable collector. Repeat this step for the second AS EC QDE cable.

NOTE: The 700 Series™ control head uses a cable collector for the Quick Disconnect Mount and the In-Dash Mount. See your control head installation guide for details.

2.Connect the AS EC 10E to each round connector on the AS EC QDE cables.

3.Hand-tighten the screw nut(s) on each cable to secure the connection. The connectors are keyed to prevent incorrect installation, so be careful not to force the connectors.

B.One 700 Series™ Unit & One 800/900/1100 Series™ Unit

1.Insert the AS EC QDE Ethernet cable connector into the Ethernet slot on the 700 Series™ cable collector.

NOTE: The 700 Series™ control head uses a cable collector for the Quick Disconnect Mount or the In-Dash Mount. See your control head installation guide for details.

2.Insert one end of the AS EC 10E cable into the Ethernet port on the back of the 800/900/1100 Series™ control head. The connectors are keyed to prevent incorrect installation, so be careful not to force the connectors into the port.

Installation

4

Contents

Page Thank You Page Table of Contents Introduction 1. Installing an Ethernet Connection 2. Powering On 3. Configuring the Ethernet Network Troubleshooting Humminbird® Accessories Contact Humminbird® Page Introduction 1.Connect two Humminbird® units together 2.Power On 3.Configure your Humminbird® Ethernet Network 4.Share Navigation Data 1. Installing an Ethernet Connection Ethernet Cable Information Control Heads Required Cables Connect the Control Heads 1.Confirm that the control heads are powered off A. Two 700 Series™ Units 2.Connect the AS EC 10E to each round connector on the AS EC QDE cables B.One 700 Series™ Unit & One 800/900/1100 Series™ Unit 3.Connect the AS EC QDE cable connector to the AS EC 10E cable connector 4.Hand-tightenthe screw nut(s) on each cable to secure the connection C. Two 800, 900, or 1100 Series™ Units 3.Hand-tightenthe screw nut(s) on each cable to secure the connection Page 2. Powering On 1.Press the POWER/LIGHT key 3. Configuring the Ethernet Network 1.Network Setup Overview 2.Customize the Unit Name 4.Understand the Shared and Local Menu Settings 5.Share Navigation Data Page Network Menu tab Customize the Unit Name 1.Main Menu: Press the MENU key twice. Select the Network Menu tab Open the Network Source Setup Dialog Box Sonar Source Overview Shared Sonar Menu Settings Select a Sonar Source Page Change the Sonar Source Page Temperature Source Overview Shared Temperature Menu Settings Select a Temperature Source Select Temperature Sources for Digital Readout Boxes 5.Repeat steps 2 - 4 to select a different temperature tab for more information Change the Temperature Source Page GPS and Navigation Data Overview Select a GPS Source Page Change the GPS Source Share Navigation Data Shared Navigation Menu Settings Share Man Overboard (MOB) Navigation Page Restore Defaults (Setup Menu Tab) Use this menu choice with caution Fishing System Doesn’t Power Up Fishing System Defaults to Simulator with a Transducer Attached Humminbird® Accessories Page Contact Humminbird® Contact the Humminbird® Customer Resource Center in any of the following ways: By Telephone: By e-mail: