Change the Sonar Source

To change the sonar source, open the Network Source Setup dialog box and change the transducer source at any time (see Select a Sonar Source). Network settings are saved even after the unit is powered off.

If the control head cannot detect the set transducer, an error message displays so that you can reset the transducer source as follows:

•If the shared transducer is not detected on the network, follow the on-screen instructions to switch to the transducer connected to the control head.

•If the local transducer is not detected, follow the on-screen instructions to switch to another transducer in the network. If there is more than one transducer in the network, you can select a different transducer from the Network Source Setup dialog box. See Select a Sonar Source for details.

Sonar Sources

16