Select a GPS Source

When you power on the network for the first time, the control head will automatically choose the connected or internal GPS receiver to provide data to the control head. Use the instructions below to select a GPS source for your control head.

Select a GPS Source

1.Open the Network Source Setup dialog box.

2.Select the GPS Tab: Press the RIGHT Cursor key until the tab is selected.

3.Scroll: Press the DOWN or UP Cursor keys. The selected source is highlighted in white.

4.Select: Press the ENTER/INFO key or the RIGHT Cursor key. The check mark indicates that the source is being used by the control head.

5.Save: Press the EXIT key to close the dialog box. Follow the on-screen instructions to save your changes. To select No, press the LEFT Cursor key. To select Yes, press the RIGHT Cursor key. Network settings are saved even after the unit is powered off.

Local Setup: To use separate GPS receivers for each control head, repeat steps 1 - 5 on each control head until you’ve set a GPS receiver for each unit.

Shared Setup: To use the same GPS receiver with more than one control head, repeat steps 1 - 5 on each control head and select the same GPS receiver on all units.

Menu System: When you select a GPS source, the control head updates with the corresponding menu options and views. If the GPS is shared between control heads, it may take a moment for the data to synchronize. See GPS and Navigation Data Overview for more information.

25

GPS Sources