4.Select: Press the ENTER/INFO key or the RIGHT Cursor key. The check mark indicates that the source is being used by the control head.

5.Save: Press the EXIT key to close the dialog box. Follow the on-screen instructions to save your changes. To select No, press the LEFT Cursor key. To select Yes, press the RIGHT Cursor key. Network settings are saved even after the unit is powered off.

Local Setup (default): To use separate transducers for each control head, repeat steps 1 - 5 on each control head until you’ve set a transducer for each unit.

Shared Setup: To use the same transducer with more than one control head, repeat steps 1 - 5 on each control head and select the same transducer for all units.

Menu System and Views: When you select a sonar source, the control head updates with the corresponding menu options and views. If the transducer is shared between control heads, it may take a moment for the data to synchronize. See Sonar Source Overview for more information.

Selecting a Transducer

Press the

RIGHT or LEFT Cursor key to

select a tab.

Available

Sonar Sources

Unit Name

Unit Model

Transducer

Beam

Column

Number

Model

Frequencies

(see Customize

Column

Column

Column

the Unit Name)

 

 

 

Selected

The check mark indicates the transducer is used by the control head.

Empty

The empty box indicates the transducer data is available but not selected. You must select a transducer to display its data on the control head.

15

Sonar Sources