531569-1_B - 955c ManE.qxp 3/4/2007 5:03 PM Page 8
1Power
2Temp/Speed
3Communications
4Cable Collector Insert
5
1 2 3
4
Plug Cable Connector Assembly to
Back of Control Head
10.While holding cables in place in the cable collector insert, thread the cables through the slot in the bottom of the cable collector cover, line up the cable collector insert and cover, then slide the cover into place on the insert.
NOTE: The tab on the Cable Collector insert goes into the slot on the cover.
1
3
2
4
5
1 Cable Collector Insert
2 Screws
3 Cable Collector Cover
4 Tab on Insert
5 Slot on Cover
10.Attach the cable collector insert to the cable collector cover using the 2 Phillips screws provided.
11.Place the control head back onto the mounting bracket. Plug in the cable collector assembly to the back of the control head. Cable connectors and cable sockets are keyed to prevent reverse installation, so be careful not to force the connectors into the wrong sockets. Once the cable collector and all cables are plugged into the back of the control head, lock the assembly into place by threading the knurled screw into the threaded insert on the back of the housing. Adjust the control head to the desired viewing angle and secure by tightening the gimbal knobs.
NOTE: You may wish to dress the cabling with nylon wire ties in order to hold the cables together and create a cleaner assembly.
The Humminbird® 900 Series™ control head is now ready for operation.
8
