CONNECTING AN SRR OR ICR REMOTE CONTROL (NOT INCLUDED) .........................
The ICC controller is shipped with a SmartPort® wiring harness, allowing for fast and easy use of the Hunter SRR or ICR remote control. The remote makes it possible for contractors and end users alike to operate a system without having to walk back and forth to the controller.
To utilize the SRR/ICR Remote Control System you must install the SmartPort® outlet.
1. | Install a 1/2" female threaded “Tee” in the field wiring conduit |
| approximately 12" below the ICC. |
2. | Feed the red, white, and blue wires of the harness through the base |
| of the “Tee” and into the wiring compartment as shown in below. |
Power Module
Blue
White
Red
3. | Screw the SmartPort® harness housing into the “Tee” as shown. |
4. | Access the terminal strip area and attach the red wire to the bottom |
| most AC screw slot, attach the white wire to the upper AC screw |
| slot and attach the blue wire to the screw slot marked “REM.” |
To Controller
1/2" Thread
The SmartPort® is now ready for remote control use. Please refer to the SRR or ICR owner’s manual for further information or contact your local Hunter distributor for ordering information.
Indoor Installation |
Outdoor Installation |
(Temporary Connection |
of Receiver Only) |
Controller |
Receiver |
16