PROGRAMMING THE CONTROLLER (continued) ..............................................................
RUN | RUN |
After programming is complete, turn the dial to RUN to enable automatic execution of all selected programs and start times. Watering will not occur unless dial is in the RUN position.
WEATHER SENSOR
BYPASS
MANUALLY RUN A SINGLE STATION
1.Turn the dial to the MANUAL- SINGLE STATION position.
2.Station run time will flash in
the display. Use the button to move to the desired station.
You may then use the and buttons to select the
amount of time for a station to water.
MANUAL SINGLE STATION
With this
3. Turn the dial to the RUN position to run the station (only the designated station
will water, then controller will return to automatic mode with no change in the previously set program).
with the Hunter
SYSTEM OFF | SYSTEM OFF |
Valves currently watering will be shut off after the dial is turned to the SYSTEM OFF position for two
MANUALLY RUN ALL STATIONS
1.Turn the dial to
2.You can select program A, B, C, or D by pressing the button.
3.Press the button until desired starting station is displayed.
MANUAL ALL
STATION
seconds. All active programs are discontinued and watering is stopped. To return controller to normal automatic operation, simply return dial to RUN position.
4. Station run time will flash in
the display. Use the |
| and |
|
buttons to select the amount of run time for the station to water if different from the run time displayed.
26