Placards | Husqvarna 155, 155 AWD manual

EXPLANATION OF SYMBOLS AND DECALS

Placards

8009-442

8 – English

Image 10

Husqvarna 155, 155 AWD manual Placards

Contents

Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. Children IV. Service Safe handling of gasoline Towing of the machine Travel and transport on public roadsIntended use Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Placards Safety Instructions Safety Instructions Safety Instructions Personal Safety Equipment Slope Operation Children Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controls Speed limiter Throttle and Choke leverParking brake Cutting unit Lift lever for the cutting unit Seat Lever for adjustment of cutting heightRefueling Starting the engine OperationBefore starting Cold engine Warm engine To start an engine with a weak battery To remove cables, reverse order Running Moving tips Stopping the engine MAX1015 Rear Axle Release leverFront Axle Maintenance Maintenance schedule Cleaning and washing Avoid using a high pressure washer or a steam cleaner Front hood Dismantling of the machine hoodsEngine hood Right-hand fender Checking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWD Adjusting the throttle wire Inspecting the mufﬂer Replacement of the fuel filter Replacing the air filter Check the level of the battery acid Procedures on contact with acid Ignition system Fitting the wrong spark plug type can damage the engine Checking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unit Placing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the blades Removal of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Change of oil filter Check the transmission’s oil level Lubricating the belt adjuster General lubrication Trouble Shooting Schedule Problem Procedure Winter storage ServiceStorage Cover Technical Data Technical Data After first 5 hours ServicejournalPre-delivery service Work done Date, mileage, stamp, sign ´z+R23¶5L¨ Page 115 01