Removal of BioClip plug Combi | Husqvarna 155, 155 AWD guide

MAINTENANCE

Removal of BioClip plug (Combi)

To change a Combi unit from BioClip function to cutting unit with rear ejection, remove the BioClip plug located under the unit with three screws.

1.Put the unit in the service position, see "Placing in the service position".

2.Remove the three screws holding the BioClip plug, and remove the plug.

3.Tip: Fit three full-thread screws M8x15 mm in the screw holes to protect the threads.

4.Replace the unit in normal position.

Fit the BioClip plug in the reverse order.


	Service position	6017-227

Removal of BioClip plug

8009-289

English – 47

Image 49

Husqvarna 155, 155 AWD manual Removal of BioClip plug Combi

Contents

Rider 155 Rider 155 AWD Page Contents Introduction Manufacturing Number Good ServiceEngine Transmission General operation Safe operation practices for ride-on mowersII. Slope operation III. Children Safe handling of gasoline IV. Service Towing of the machine Travel and transport on public roadsIntended use Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and Decals Placards Safety Instructions Safety Instructions Safety Instructions Slope Operation Personal Safety Equipment Children Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls Controls Speed limiter Throttle and Choke leverParking brake Lift lever for the cutting unit Cutting unit Seat Lever for adjustment of cutting heightRefueling Before starting OperationStarting the engine Cold engine Warm engine To remove cables, reverse order To start an engine with a weak battery Running Moving tips MAX1015 Stopping the engine Rear Axle Release leverFront Axle Maintenance schedule Maintenance Avoid using a high pressure washer or a steam cleaner Cleaning and washing Engine hood Dismantling of the machine hoodsFront hood Right-hand fender Checking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brake Inspecting the mufﬂer Adjusting the throttle wire Replacing the air filter Replacement of the fuel filter Procedures on contact with acid Check the level of the battery acid Fitting the wrong spark plug type can damage the engine Ignition system Checking the safety system Checking the tire pressure Main fuseCheck the engine’s cooling air intake Observe caution to avoid trapping your hand Fitting the cutting unit Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unit Placing in service position Service position for the cutting unitBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service position Removal of BioClip plug Combi Check the engine’s oil level LubricationChanging the oil Check the transmission’s oil level Change of oil filter General lubrication Lubricating the belt adjuster Problem Procedure Trouble Shooting Schedule Storage ServiceWinter storage Cover Technical Data Technical Data Pre-delivery service ServicejournalAfter first 5 hours Work done Date, mileage, stamp, sign ´z+R23¶5L¨ Page 115 01