CONTROLS

Lever for adjustment of cutting height

With this lever the cutting height can be adjusted to 9 different positions.

Combi,

40-90 mm

 

(1 9/16" - 3 9/16")

IMPORTANT INFORMATION

In order to obtain an even cutting height it is important that the air pressure in all four tires is the same 8,5 psi (0,6 bar).

Seat

The seat has a jointed attachment on the front edge and can be tipped forward.

The seat can also be adjusted lengthways.

Release the knobs under the seat and adjust it forwards or backwards to the required position.

Lock the setting with the knobs.

Refueling

The machine has one fuel tank, just behind the seat. The tank capacity is 1,8 gallons (7 liters). The engine will run on a minimum of 85-octane unleaded gasoline (no oil mix). Environmentally adapted alkylate gasoline can be used. See also Technical Data concerning ethanol fuel. Methanol fuel is not allowed.

WARNING!

Gasoline is highly flammable. Observe caution and fill the tank outdoors (see the safety rules).

WARNING!

The engine and the exhaust system, become very hot during operation. Risk for burns if touched. Allow engine and exhaust system to cool at least two (2) minutes before refueling.

WARNING!

Fill to bottom of filler neck. Do not overfill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

When operating in temperatures below 32° (0° C.), use fresh, clean winter grade gasoline to help insure good cold weather starting.

6004-013H

6004-014H

6004-015

English – 21

Page 23
Image 23
Husqvarna 155, 155 AWD manual Lever for adjustment of cutting height, Seat, Refueling