Stopping the engine, MAX1015 | Husqvarna 155, 155 AWD guide

OPERATION

WARNING!

Never drive the machine on ground with a slope of more than 10°. Mow slopes upwards and downwards, never across. Avoid sudden changes in direction.

Operating on hills

Read the Safety Instructions “Driving on Slopes” in the “Safety Instructions”.

MAX1015

6017-247

•The slowest speed possible should be used before starting up or down hills.

•Avoid stopping or changing speed on hills.

•If stopping is absolutely necessary engage the parking brake.

•To restart movement, release the parking brake.

•Make all turns slowly.

Stopping the engine

Preferably allow the engine to idle for a minute to obtain normal working temperature before stopping it if it has been working hard.

1.Lift up the cutting unit by pulling the lever back to the end position.

2.Pull back the throttle control and turn the ignition key to the STOP position.

3. When the Rider is at a standstill, press down the

parking brake and push in the locking button.

	6007-014H
STOP	START
	6007-015
	English – 27

Image 29

Husqvarna 155, 155 AWD manual Stopping the engine, MAX1015

Contents

Rider 155 Rider 155 AWD Page Contents Introduction Engine Transmission Good ServiceManufacturing Number General operation Safe operation practices for ride-on mowersII. Slope operation III. Children Safe handling of gasoline IV. Service Intended use Travel and transport on public roadsTowing of the machine Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Explanation of Symbols and Decals Placards Safety Instructions Safety Instructions Safety Instructions Slope Operation Personal Safety Equipment Children Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Location of the controls Controls Parking brake Throttle and Choke leverSpeed limiter Lift lever for the cutting unit Cutting unit Refueling Lever for adjustment of cutting heightSeat Before starting OperationStarting the engine Cold engine Warm engine To remove cables, reverse order To start an engine with a weak battery Running Moving tips MAX1015 Stopping the engine Front Axle Release leverRear Axle Maintenance schedule Maintenance Avoid using a high pressure washer or a steam cleaner Cleaning and washing Engine hood Dismantling of the machine hoodsFront hood Right-hand fender Checking and adjustment of the steering wires Adjusting the Parking Brake Rider 155 AWD Adjusting the parking brake Inspecting the mufﬂer Adjusting the throttle wire Replacing the air filter Replacement of the fuel filter Procedures on contact with acid Check the level of the battery acid Fitting the wrong spark plug type can damage the engine Ignition system Checking the safety system Check the engine’s cooling air intake Main fuseChecking the tire pressure Observe caution to avoid trapping your hand Fitting the cutting unit Checking the cutting unit’s parallelism Removing the cutting unit Adjusting the parallelism of the cutting unit Belt replacement on the cutting unit Service position for the cutting unitPlacing in service position Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Checking the blades Restoring from service position Removal of BioClip plug Combi Changing the oil LubricationCheck the engine’s oil level Check the transmission’s oil level Change of oil filter General lubrication Lubricating the belt adjuster Problem Procedure Trouble Shooting Schedule Storage ServiceWinter storage Cover Technical Data Technical Data Pre-delivery service ServicejournalAfter first 5 hours Work done Date, mileage, stamp, sign ´z+R23¶5L¨ Page 115 01