MAINTENANCE
Belt replacement on the cutting unit
On these cutting units with
1.Remove the cutting unit, see page 38.
2.Undo the bolt on the lift strut and the two screws on the cover. Lift the cover off the cutting unit.
3.Loosen the spring that tensions the
Simply reverse the procedure to fit the new belt.
Service position for the cutting unit
The cutting head can be placed in the service position to provide easy access for cleaning, repairs and servicing. In service position, the cutting unit is raised and locked in the vertical position.
Placing in service position
1.Position the machine on flat ground. Apply the parking brake (A). Adjust the cutting unit to the lowest cutting height and lower the cutting unit
(B).
2.Remove the front hood by removing the pin. (There are complete instructions on using the service position inside the front hood).
English – 43
