MAINTENANCE

WARNING!

Before performing any service or adjustment checklist:

1.Engage the parking brake.

2.Place the Blade-switch in the disengaged position.

3.Turn ignition switch to “OFF” position and remove the key.

4.Make sure the blades and all moving parts have completely stopped.

5.Disconnect the spark plug wire from all spark plugs and place the wire where it cannot come in contact with the plug.

Fitting the cutting unit

1.Place the Rider on a flat surface and apply the parking brake. Check that the lever for setting the cutting height is in the lowest position.

Make sure the support wheels are fitted to the cutting unit (1).

2.Grasp the handle at the front (BioClip 90) or hold the frame of the cutting unit (2) and slide the unit underneath the rider mower, making sure that the tongue on the cutting unit (3) engages correctly.

3.Insert the bolt and secure it with a locking pin.

WARNING!

Observe caution to avoid trapping your hand.

4.Press down the frame and insert the pin. Fit the drive belt around the drive wheels of the cutting unit.

5.Hook up the height adjustment strut.

6.Fit the front cover.

7.Secure the collet’s spring, see ring in the diagram below.

3

1

2

6017-159

8009-438

6017-120

6017-160

40 – English

Page 42
Image 42
Husqvarna 155, 155 AWD manual Fitting the cutting unit, Observe caution to avoid trapping your hand