Release lever, Rear Axle, Front Axle | Husqvarna 155, 155 AWD

OPERATION

Release lever

The release control must be pulled out in order for the Rider to be moved when the engine is shutoff.

6007-217H

Pro 155 AWD has one control for the front axle and one control for the rear axle.

Pull the controls to their end positions. Do not use an intermediate position.

Rear Axle

The control is positioned on the inside of the left rear wheel.

• Control pulled out, drive system disengaged.

• Control pushed in, drive system engaged.

Rider 155 AWD rear

Front Axle

The control is positioned on the inside of the left front wheel.

• Rear control (pulled out), drive system disengaged.

• Forward control (pushed in), drive system engaged.

Rider 155 AWD front

6021-028

6021-

28 – English

Image 30

Husqvarna 155, 155 AWD manual Release lever, Rear Axle, Front Axle

Contents

Rider 155 Rider 155 AWD Page Contents Introduction Good Service Manufacturing NumberEngine Transmission II. Slope operation Safe operation practices for ride-on mowersGeneral operation III. Children IV. Service Safe handling of gasoline Travel and transport on public roads Towing of the machineIntended use Explanation of Symbols and Decals Xxxxxxx xxxx xxxxxxxx xxx Xxxx xxxxxx Placards Safety Instructions Safety Instructions Safety Instructions Personal Safety Equipment Slope Operation Children Maintenance General Maintenance Always use protective glasses when handling the battery Transport Customer responsibilities Controls Location of the controls Throttle and Choke lever Speed limiterParking brake Cutting unit Lift lever for the cutting unit Lever for adjustment of cutting height SeatRefueling Starting the engine OperationBefore starting Cold engine Warm engine To start an engine with a weak battery To remove cables, reverse order Running Moving tips Stopping the engine MAX1015 Release lever Rear AxleFront Axle Maintenance Maintenance schedule Cleaning and washing Avoid using a high pressure washer or a steam cleaner Front hood Dismantling of the machine hoodsEngine hood Right-hand fender Checking and adjustment of the steering wires Adjusting the parking brake Adjusting the Parking Brake Rider 155 AWD Adjusting the throttle wire Inspecting the mufﬂer Replacement of the fuel filter Replacing the air filter Check the level of the battery acid Procedures on contact with acid Ignition system Fitting the wrong spark plug type can damage the engine Checking the safety system Main fuse Checking the tire pressureCheck the engine’s cooling air intake Fitting the cutting unit Observe caution to avoid trapping your hand Checking the cutting unit’s parallelism Adjusting the parallelism of the cutting unit Removing the cutting unit Service position for the cutting unit Placing in service positionBelt replacement on the cutting unit Remove the two support wheels from under the front hood 8009-122 6017-223 6017-225 6017-226 Restoring from service position Checking the blades Removal of BioClip plug Combi Lubrication Check the engine’s oil levelChanging the oil Change of oil filter Check the transmission’s oil level Lubricating the belt adjuster General lubrication Trouble Shooting Schedule Problem Procedure Winter storage ServiceStorage Cover Technical Data Technical Data After first 5 hours ServicejournalPre-delivery service Work done Date, mileage, stamp, sign ´z+R23¶5L¨ Page 115 01