3.INSTALLATION

7.Refit the cover on the charging station. Ensure the three guides on the charging station enter the right holes in the cover.

3.6 Checking the installation

Check the loop signal by looking to see what indication the green LED on the charging station is giving.

• Steady light = the signal is okay.

• Flashing once every other second = break in the loop and no signal found.

• Flashing twice every other second = weak signal. This may be due to the boundary wire exceeding 500 metres or that the cable is damaged. If the mower works, it is not a problem. In case of operational disturbance, we recommend a Signal amplifier (522 42 58-01) which is available as an accessory. This allows a boundary wire of up to

800metres.

3.7Linking Automower® to the charging station

1.Open the control panel cover by pressing the STOP button.

2.Place Automower® in the charging station.

3. Set the main switch to the ON position.

A start-up sequence begins when Automower® is started for the first time. The following is requested: Language, time format, correct time, date format, date, and four-digit PIN code. All combinations except 0000 are permitted.

When you have chosen a PIN code with Automower® placed in the charging station, the mower and charging station are then linked to each other.

ON

OFF

32 - English

Page 32
Image 32
Husqvarna 265 ACX manual Checking the installation, Linking Automower to the charging station