Charging the battery | Husqvarna 265 ACX specification

3.INSTALLATION

3.3Charging the battery

Automower® is supplied with an uncharged battery. As soon as the charging station is connected, it is possible to charge the mower.

1.Set the main switch to the ON position.

2.Place Automower® in the charging station to charge the battery while you are laying the boundary wire.

From an uncharged state the battery takes about 1 to 2 hours until it is fully charged.

IMPORTANT INFORMATION

Automower® cannot be used before the installation is complete.

22 - English

Image 22

Husqvarna 265 ACX manual Charging the battery, Automower cannot be used before the installation is complete

Contents

Husqvarna Automower 265 ACX OPERATOR’S Manual Page Table of Contents Table of Contents Introduction and safety Introduction Symbols on Automower Xxxxxx xxxxx xxxx xxxx xxxxx Symbols in the Operator’s ManualImportant Information Xxxxxx xxxxx xxxx xxxx xxxxx Safety instructions Use Maintenance Transport Presentation Automower, what’s what? Capacity Function of AutomowerMowing technique Working method Movement pattern Search method Search method 2 Follow boundary wireSearch method 3 Follow guide wire Search method 1 Irregular One Automower in several gardens More than one Automower in a gardenGPS communication unit Carry out the installation in the following steps InstallationPreparations Installation of the charging station Best charging station location Important Information Installation Installation and connecting the charging station Do not tread or walk on the charging station plate Charging the battery Automower cannot be used before the installation is complete Installation of the boundary wire Best position for the boundary wire Boundaries for the working area Boundaries within the working area Secondary areas Passages when mowing Passages when searching for the charging station Slopes Laying out the boundary wire Laying the boundary wire in towards the charging station Joining the boundary wire Connecting the boundary wire Installation Checking the installation Linking Automower to the charging station Installation of the guide wire Need of a guide wire Placement and connection of the guide wire Maximum 135º 90º Activate the GPS anti-theft Protection area Charging a discharged battery Use Using GPS-communication Using the timerSMS feature Remarks Commands Description CommandsGPS anti-theft protection Starting Automower Restart Switching off AutomowerStopping Automower Restart within 20 seconds Adjusting the cutting height Control panel Shortcuts Main switch Numbers Browse between menus Menu functionsMain menu Number series Automower Main menu Commands Timer Start time 1 Stop time 1 Start time 2 Stop time 2 Reset all timersYES Mon Tue Wed Thu Fri Sat Sun Run all Start angle 1 InstallationReversing distance End angle 1 Passage where the charging station cannot be To follow the boundary wire or a guide wire awayGardens where the front and back are joined by a When this function is activated Automower will Proportion DirectionDistance Follow loop Corridor width Test Test OUT Open SettingsDrive past wire Normal PIN code Time lock4-1-2 Alarm4-1-3 GPS Time format Set timeSet date Date format Proposed installation and settings Garden example Exit angles Exit angles 250 Corridor width Guide 1 Exit angles 70 Maintenance Battery Automower ServiceWinter storage Charging station Underframe and blade disc CleaningAfter winter storage Chassis Transport and moving Replacing the bladesBody Trouble shooting Fault messages Trouble Shooting Trouble Shooting Fault symptom Data Automower 265 ACX Technical dataData GPS communication unit Environmental information Environmental Information EU declaration of conformity EU Declaration of Conformity only applies to EuropePage Page Original Instructions