6. MENU FUNCTIONS
Different corridor widths can be set for the boundary wire, guide 1 and on guide 2. The default setting on Automower® is set to a value of 19 for both the boundary wire and guide wires.
The higher the stated Corridor width value, the less risk there is of tracks forming. However, a high corridor value means that Automower® may find it difficult to enter passages.
A garden with large open areas should have a wide Corridor, i.e. a high Corridor width value. A garden with passages should have a narrow Corridor, i.e. a low value for the Corridor width.
When the value is set to 0 for the Corridor width, Automower® will run along the boundary wire, which means it will run with half the mower inside the loop and half the mower outside. As there are often flower beds, hedges and walls along with the boundary wire Corridor width 0 is not normally recommended. Should you still like to state this value, the boundary wire must lay
50 cm from solid objects instead of the normal
40 cm.
IMPORTANT INFORMATION
The distance at which the mower follows the boundary wire varies depending on how the working area appears. You should perform some tests to find the highest possible Corridor width. Use the Test IN
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
Boundary corridor
Guide 1 corridor
Guide 2 corridor
•Test IN
The Test IN
Follow loop out
Follow loop in
Corridor width
Test IN
Test OUT
English - 55
