Husqvarna 265 ACX manual Trouble shooting, Trouble Shooting, Fault messages, Cause, Action

9.TROUBLE SHOOTING

9.Trouble shooting

9.1 Fault messages

A number of fault messages are listed below that can be shown on Husqvarna Automower®. If the same fault occurs frequently: contact your dealer.

Fault message	Cause	Action
Left wheel motor	Grass or other object has wrapped	Check the drive wheel and remove
blocked	around the drive wheel.	the grass or other object.
Right wheel motor	Grass or other object has wrapped	Check the drive wheel and remove
blocked	around the drive wheel.	the grass or other object.
Blade disc blocked	Grass or other object has wrapped	Check the blade disc and remove the
	around the blade disc.	grass or other object.
No loop signal	The transformer is not connected to	Check the wall socket connection and
	the mains supply or its miniature	whether the miniature circuit-breaker
	circuit-breaker has tripped.	has tripped.
		Reset the miniature circuit-breaker by
		removing the transformer’s power
		cord from the wall socket, wait
		10 seconds and then reconnect the
		power cord in the wall socket again.
	The boundary wire is not connected	Check the signal given by the LED in
	to the charging station.	the charging station. If it flashes, it
		may be that the boundary wire is not
		connected. Check that the boundary
		wire’s connectors are properly
		connected to the charging station.
	Boundary wire broken.	Check the signal given by the LED in
		the charging station. If it flashes the
		loop may be damaged. Repair the
		break on the wire using the original
		coupler.
	The connection between Automower®	Place Automower® in the charging
	and the charging station has been	station and change the PIN-code via
	lost.	Settings - Security - PIN code
		(shortcut 4-1-1). You can use the
		same PIN code as earlier.
	This may be due to the boundary wire	Check that the boundary wire has
	being routed in the wrong direction	been routed correctly.
	around an ”island”, which blanks out
	the signal.
	If this occurs in isolated areas it may	Try moving the boundary wire.
	be due to interference from metallic
	objects (perimeter fence,
	reinforcement bar) or buried cables in
	the vicinity.
Trapped	Automower® has got caught in	Free Automower® and rectify the
	something.	reason for it getting trapped.

English - 69