3. INSTALLATION
3. Installation
This chapter describes how you install the Husqvarna Automower®. Before starting the installation read the previous chapter 2. Presentation.
Read also through this entire chapter before beginning the installation. How the installation is made also affects how well Automower® will work. It is therefore important to plan the installation carefully.
Planning is simplified if you make a sketch of the working area, including all obstacles. This makes it easier to see the ideal positions for the charging station, the boundary wire and the guide wire. Draw on the sketch where the boundary and guide wires should be routed.
In chapter 7. Garden examples, there are examples of installations.
Visit also www.automower.com for further descriptions and tips regarding installation.
Carry out the installation in the following steps:
3.1Preparations.
3.2Installation of the charging station
3.3Charging the battery.
3.4Installation of the boundary wire.
3.5Connecting the boundary wire.
3.6Installation of the guide wire.
3.7Checking the installation.
3.8First
3.9Test docking with the charging station
The charging station and boundary and guide wires must be connected to be able to carry out a complete
3.1 Preparations
1.If the lawn in the proposed working area is taller than 10 cm, mow it using a normal robotic lawn mower. Then collect the clippings.
2.Read carefully through all the steps before the
installation.
3.Check that all parts for the installation are included. The numbers in brackets refer to the detail diagram 2.1 What’s what?.
• Operator’s Manual (24)
•Automower®
•Charging station (6)
•Loop wire for the boundary wire and guide wire (16)
English - 15
